Constructive Breeding |
| Date Added: May 16, 2008 05:37:48 AM |
| Author: Apex Pitbulls |
| Category: Blue Nose Breeders |
| The Breeder- A person who has on his premises one or more bitches which are mated for commercial purposes-for sale as pets, as guide dogs, or to produce potential show, field, or obedience dogs. The serious breeders are highly interested in the genetics aspect of breed improvement. The entire process of the care and management of dogs, the exercise of good judgement is involved, Upon the choice of the two dogs, male and female to be mated together depends on the future success or failure of one’s dogs. If the two dogs to be bred are ill chosen either individually or as a pair, all the painstaking car to feed and rear the resulting puppies is wasted. The mating of two dogs is the drafting of the blueprints and the writing of the specification of what the puppies are to be like. The plans, it is true, require to be executed; the puppies when they arrive must be adequately fed and cared for in order to develop them into the kinds of dogs they are in their germ plasm designed to become. However, if the plans as determined in the mating are defective, just so will the puppies that result from them be defective, just so will the puppies that result from them be defective, in spite of all the good raising one can give them. The element of luck in the breeding of dogs cannot be discounted, for it exists. The mating which on paper appears to be the best possible may result in puppies that are poor and untypical of breed. Even less frequently, a good puppy may result from chance mating together to two ill chosen parents. The results are fortuitous and unusual, however the best dogs as a lot come from parents carefully chosen as to their individual Excellencies and as to their suitability as mates for each other. It is as unwise as it is unnecessary to trust, luck, in the breeding of dogs. Careful planning pays off in the long run, and few truly excellent dogs are produced without it. Some breeders without any knowledge of genetics have been successful, without knowing exactly why they succeeded. Some of them have adhered to beliefs in old wives’ tales and to traditional concepts that science ha long since exploded and abandoned. Best to Best- Breed the best to the best was an early breeder, named Roberty Bakewell’s axioms. This led to the mating of superior animals regardless of relationship and this frequently led to extremely close mating. He thereby introduced inbreeding as a tool in breed improvement. Like begets Like- It is questionable whether Bakewell in practice carried this advantage to the extreme, some of his adherents did in latter years. Bakewell merely maintained that superior animals were more likely to produce superior offspring than inferior individuals. He was therefore, very critical in his selection of breeding stock, no only as to appearance but as to performance and, as to breeding performance. Inbreeding may be defined as the mating of animals which are more Closely related than the average of the breed. By inbreeding the number of ancestors is necessarily reduced, but the number of ancestral places remains the same. Reasons for closebreeding There are several rather specific reasons for inbreeding. The first is the purification of bloodlines. Inbreeding induces segregation; Hence continued inbreeding accompanied by rigorous selection for certain characteristics is the quickest and most certain method of fixing desirable traits, undesirable traits are, however, fixed with as much rapidity and sometimes it appears they are fixed with even more ease than desirable traits; hence the selection should always be directed as the traits sought in the line after they are purified. Inbreeding neither adds nor subtracts from the line, it merely brings out what is bred and offers the breeder the opportunity of selecting more intensively than he otherwise would. It is a mistake to start inbreeding until one has reason to believe that he has something good in the line, on the other had, it’s a mistake to delay inbreeding after something good has been found because each outcross eliminates exactly one-half of the hereditary material already in the breeding. Undesirable traits, as mentioned earlier, comes with inbreeding. Therefore corrective mating has their place in constructive breeding. The corrective mating should be made for the specific purpose of correcting some definite defect in a stock of strain. The outcross needs to be followed by a certain amount of inbreeding, however, in order to fix the character in the strain; otherwise it is likely to be lost in subsequent outcrossing. |
You must be logged in to leave a rating.Average rating: ( votes) |